Powermadd Star Series 34253 Hand Wrap Kit Bedienungsanleitung PDF herunterladen

PowerMadd M 34253 Rev C

651-462-8465 www.powermadd.com

POWERMADD

Hand Wrap Kit

Installation Instructions for Part No. 34253

NOTE: This kit is an accessory to the Star Series Handguard and Handguard Mounting Kit.

HARDWARE INCLUDED: TOOLS REQUIRED:

Qty Description Power Drill

2 Brackets 3/16” Drill Bit

2 Flat Head Screws 1/4” Drill Bit

2 Button Head Screws 5mm Hex Wrench

2 Clamp Inserts 4mm Hex Wrench

2 Cone Inserts Hack Saw

2 Rubber Hose Utility Knife

2 Flange Nut

NOTE: Both Hand Wrap brackets have a bend next to where they mount to the handlebar to give relief for the hands. One

bracket is specifically for the throttle side and the other is for the clutch side. These instructions will explain how to install one

side. Then repeat the instructions for the other side. You must have 7/8” bars that are hollow for this system to work.

STEP 1: Take one of the Hand Wrap brackets and clamp the end

without the threaded hole into a vise. It will require two hands

to drill the hole in the handguard for mounting the bracket.

STEP 2: The end of the bracket with the threaded hole fits into the

backside of the handguard. With a 3/16” drill bit and using the

threaded hole as a guide, drill through the handguard as you

hold it up to the bracket.

STEP 3: Remove the handguard from the bracket and use a 1/4” drill bit

to increase the size of the hole drilled in the handguard from

STEP 2. Repeat STEP 1-3 for other handguard.

NOTE: If your handlebar setup already has holes in the end of each grip,

skip to STEP 5, otherwise continue with STEP 4.

STEP 4: Clutch Side: Cut or drill a ½” hole in the end of the grip or

completely cut the end of the grip off. The best way is to drill

a hole in the grip.

Throttle Side: Remove the throttle tube from the handlebars.

Cut or drill a 9/16” hole in the end of the grip and throttle tube

or use a knife to cut off the end of the grip and a hack saw to

cut off the end of the tube. Then reinstall the throttle tube onto

the handle bars.

1 2

POWERMADD 1
Hand Wrap Kit 1

Inhaltsverzeichnis

Seite 1 - Hand Wrap Kit

PowerMadd M 34253 Rev C 651-462-8465

Seite 2

PowerMadd M 34253 Rev C 651-462-8465

Kommentare zu diesen Handbüchern

Keine Kommentare

Powermadd Star Series 34253 Hand Wrap Kit Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für Motorräder Powermadd Star Series 34253 Hand Wrap Kit herunter. PowerMadd Star Series 34253 Hand Wrap Kit User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für Motorräder Powermadd Star Series 34253 Hand Wrap Kit